Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: More Extruder Rebuild
(→Machine Log: REBUILD EXTRUDER) |
(→Machine Log: More Extruder Rebuild) |
||
| Line 42: | Line 42: | ||
|Jun 8-9, 2017 | |Jun 8-9, 2017 | ||
|'''Extruder DIED!''' | |'''Extruder DIED!''' (Plate that the Tension Arm screws into is cracked/broken.) | ||
* Totally rebuild this using new printed parts. | * Totally rebuild this using new printed parts. | ||
** Everything except the Bearing Cap and the Large Gear was reprinted (on Ultimaker 1) | ** Everything except the Bearing Cap and the Large Gear was reprinted (on Ultimaker 1) | ||
** Printed with PLA using: 4 | ** Printed with PLA using: 4 Perimeter lines (1.6mm); Top/Bottom 1.6mm; 100% Fill. | ||
** Bowden Clip Holder printed at 105% (Thin washers as shims under screws.) | |||
** Everything else was printed at 100% (Which means everything is a tight fit.) | |||
* The old-style (ABS) Filament Compression Arm was labeled & put in the Printer Parts basket. | * The old-style (ABS) Filament Compression Arm was labeled & put in the Printer Parts basket. | ||
* The | * The tension block is now almost too big. (Grove side up & only goes 1/2 block length in.) | ||
* White Motor Gear moved down shaft towards Stepper Motor! (No longer meshed/engaged w/ large Extruder Gear.) | |||
** Put Gorilla Glue (Super-Glue Gel?) on motor shaft under & behind White Gear. | |||
** Move Stepper Motor over as put Large Gear back on. (Gears were toooo tight.) | |||
|Allen | |Allen | ||
|- | |- | ||