Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: update for .2mm layer for large parts
(→Status) |
(→Known Issues and Fixes: update for .2mm layer for large parts) |
||
| Line 19: | Line 19: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2 | * '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2 | ||
*Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). Turn the threaded rod counter-clockwise to | * Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. | ||
** Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). | |||
*** Turn the threaded rod clockwise to bring the head closer to the print bed, and counter-clockwise to move the head further away. | |||
** for larger parts use 0.2mm layer height (or larger) -- so that if the 2nd layer successfully prints, you get the expected flat surface to continue printing on. | |||
== Features == | == Features == | ||