251
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 8: | Line 8: | ||
Pastel Yellow PLA from filaments.ca | Pastel Yellow PLA from filaments.ca | ||
*'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''', travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | *'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''', travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | ||
**note: the reason the flow is pumped-up is because the print-head is misaligned and causing drag on the filament. I suspect you could even up the flow and the speed and get decent (but still crappy). If you want to print slower for higher precision you may need to reduce the flow | **note: the reason the flow is pumped-up is because the print-head is misaligned and causing drag on the filament. I suspect you could even up the flow and the speed and get decent (but still crappy) prints. If you want to print slower for higher precision you may need to reduce the flow (but <110% flow at any speed will cause under-extrusion) | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Changing filaments has become a pain in the neck, see Known Issues section for details. Full printhead overhaul is probably due, but meh could get a couple more print-hours out of it lol | ** Changing filaments has become a pain in the neck, see Known Issues section for details. Full printhead overhaul is probably due, but meh could get a couple more print-hours out of it lol | ||