Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: add IPG Blue Tape note
(→Known Issues and Fixes: add IPG Blue Tape note) |
|||
| Line 21: | Line 21: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting to print on Ultimaker 2 | * '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting to print on Ultimaker 2 | ||
* DO NOT USE Isopropyl Alcohol on the '''IPG Blue Tape'''. (On any other make of Blue Tape using that is fine.) | |||
* The wood support structure that holds the printbed is loose! At least on 1 side, a partial disassembly may be needed, to reverse which side the bolt heads are on, and which side the nuts are on. | * The wood support structure that holds the printbed is loose! At least on 1 side, a partial disassembly may be needed, to reverse which side the bolt heads are on, and which side the nuts are on. | ||
** '''FOR NOW:''' Grab both sides of the front '''wood''' structure (just outside the bed level screws), then gently move one side up, while the other moves down, to get the bed level. (Bed seems to stay level for printing once ajusted.) | ** '''FOR NOW:''' Grab both sides of the front '''wood''' structure (just outside the bed level screws), then gently move one side up, while the other moves down, to get the bed level. (Bed seems to stay level for printing once ajusted.) | ||