3D Printers/Ender 3 2: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== Status == <onlyinclude> * '''Works sort-of''' * '''Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm''' * '''Print-bed is ver...") |
(No difference)
|
Revision as of 04:06, 6 December 2023
Status
- Works sort-of
- Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm
- Print-bed is very low quality. Likely to cause warping on bottom of print.
- Upload G-Code to Micro-SD Card
Last Known Good Settings
| Date | Filament type, colour, brand | First layer | Other layers | Notes |
|---|---|---|---|---|