3D Printers/CR10 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
<onlyinclude> | <onlyinclude> | ||
* '''Works!''' | * '''Works!''' | ||
* ''' | * It's SD card reader has a broken latch. You have to use the octoprint web interface to upload gcode. | ||
* '''[http://octopi01.in.hacklab.to:5000 octopi01.in.hacklab.to:5000]''' | |||
</onlyinclude> | </onlyinclude> | ||
----- | ----- | ||
== Last Known Good Settings == | == Last Known Good Settings == | ||
{| cellpadding="5" cellspacing="0" border="1" | {| cellpadding="5" cellspacing="0" border="1" | ||