3D Printers/Ender 3 2: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== Status == <onlyinclude> * '''Works sort-of''' * '''Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm''' * '''Print-bed is ver...") |
(→Status) |
||
Line 23: | Line 23: | ||
|- | |- | ||
|} | |} | ||
== Maintenance Log == | |||
=== 2024-02-25 === | |||
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off. |
Revision as of 01:31, 26 February 2024
Status
- Works sort-of
- Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm
- Print-bed is very low quality. Likely to cause warping on bottom of print.
- Upload G-Code to Micro-SD Card
Last Known Good Settings
Date | Filament type, colour, brand | First layer | Other layers | Notes |
---|---|---|---|---|
Maintenance Log
2024-02-25
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off.