3D Printers/Prusa Mini 2: Difference between revisions

Jump to navigation Jump to search

3D Printers/Prusa Mini 2 (view source)

Revision as of 23:20, 26 February 2024

65 bytes removed ,  26 February
no edit summary
No edit summary
 
Line 1: Line 1:
== Status ==
== Status ==
<onlyinclude>
<onlyinclude>
* '''Broken''' (Sort-of). Watch first layer as it prints and adjust z-offset!
* '''Working Great'''
* '''http://prusa-mini-2.in.hacklab.to/'''
* '''http://prusa-mini-2.in.hacklab.to/'''
</onlyinclude>
</onlyinclude>
Line 18: Line 18:
|
|
|
|
| Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. This has now happened 3 times with the red PETG filament. Cleaning of the extender pulley also showed build of up the white PETG as well. The PEI print sheet has been significantly damaged from this.
|
 
A support case will be opened with Prusa. A new PEI build sheet will be ordered.
 
Printer should NOT be used until after the support case with Prusa is resolved.
|-
|-
|}
|}
Line 33: Line 29:
!Notes
!Notes
!Entry By
!Entry By
|-
| Dec 15, 2023
|
* Firmware update, 4.4.0 => 5.1.2. This now supports input shaping!
* Update your prusa-slicer to take advantage, you have to add a new printer model.
|
|-
| 2020-2023
| Previously, Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. A support case was be opened with Prusa. Various repair attempts were completed. This was eventually solved with various hardware and software fixes.
|
|-
|-
| July 29, 2020
| July 29, 2020
Retrieved from "https://knowledge.hacklab.to/wiki/Special:MobileDiff/2349"

Navigation menu