3D Printers/Ender 3 2: Difference between revisions
Jump to navigation
Jump to search
(→Status) |
No edit summary |
||
| Line 5: | Line 5: | ||
* '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | * '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | ||
* '''Upload G-Code to Micro-SD Card''' | * '''Upload G-Code to Micro-SD Card''' | ||
* Octoprint at '''[http://octopi04.in.hacklab.to octopi04.in.hacklab.to]''' | |||
</onlyinclude> | </onlyinclude> | ||
Latest revision as of 23:39, 26 February 2024
Status
- Works sort-of
- Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm
- Print-bed is very low quality. Likely to cause warping on bottom of print.
- Upload G-Code to Micro-SD Card
- Octoprint at octopi04.in.hacklab.to
Last Known Good Settings
| Date | Filament type, colour, brand | First layer | Other layers | Notes |
|---|---|---|---|---|
Maintenance Log
2024-02-25
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off.