3D Printers/Ender 3 1: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== Status == * Works!") |
Tags: Mobile edit Mobile web edit |
||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
== Status == | == Status == | ||
* Works! | <onlyinclude> | ||
* '''Works!''' | |||
* '''Upload G-Code to Micro-SD Card''' | |||
* Octoprint at '''[http://octopi03.in.hacklab.to octopi03.in.hacklab.to]''' | |||
</onlyinclude> | |||
----- | |||
Last Known Good Settings | |||
{| cellpadding="5" cellspacing="0" border="1" | |||
!Date | |||
!Filament type, colour, brand | |||
!First layer | |||
!Other layers | |||
!Notes | |||
|- | |||
| | |||
| | |||
| | |||
| | |||
| | |||
|- | |||
|} | |||
== Maintenance Log == | |||
=== 2024-02-25 === | |||
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off. | |||
=== 2024-02-25 === | |||
Chalms fixed the BL touch by turning off the printer, *grabbing the probe tip*, and forcing it up and down a few times. | |||
Latest revision as of 16:20, 28 March 2024
Status
- Works!
- Upload G-Code to Micro-SD Card
- Octoprint at octopi03.in.hacklab.to
Last Known Good Settings
| Date | Filament type, colour, brand | First layer | Other layers | Notes |
|---|---|---|---|---|
Maintenance Log
2024-02-25
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off.
2024-02-25
Chalms fixed the BL touch by turning off the printer, *grabbing the probe tip*, and forcing it up and down a few times.