257
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Extruder tension for TPU / flexible filaments
| (4 intermediate revisions by the same user not shown) | |||
| Line 11: | Line 11: | ||
* No filament runout sensor is installed. But one day it will be !! | * No filament runout sensor is installed. But one day it will be !! | ||
</onlyinclude> | </onlyinclude> | ||
* BL-touch flashing red? it is because the little stick at the bottom is not actuating properly because it is being stuck for some reason. To resolve, gently use your finger to pull the stick down and push it back up. Restart the printer, upon start up the BL-touch should go up and down as its start-up test | |||
----- | ----- | ||
| Line 38: | Line 40: | ||
**If all else fail then can remove the tube from the fitting by pushing down on the blue collar and pulling the tubing up. Once the filament has cleared the fitting, insert it into the tubing and re-insert the tubing into the gold fitting. MAKE SURE the tubing is firmly in the fitting or else it will get pulled out and mess up filament feeding. | **If all else fail then can remove the tube from the fitting by pushing down on the blue collar and pulling the tubing up. Once the filament has cleared the fitting, insert it into the tubing and re-insert the tubing into the gold fitting. MAKE SURE the tubing is firmly in the fitting or else it will get pulled out and mess up filament feeding. | ||
* to unload, heat up the nozzle and turn the extruder knob counter-clockwise (to the left) | * to unload, heat up the nozzle and turn the extruder knob counter-clockwise (to the left) | ||
=== Extruder tension for TPU / flexible filaments === | |||
For regular hard plastics, the tensioning knob should be well on with the screw protruding from the knob 2-3mm | |||
For TPU or flexible filaments, it needs to be MORE LOOSE or else the filament could jut out from the space below the extruder gear and above the teflon tube that goes into the heatbreak. It looks pretty funny when the filament shoots out, the filament wants to be free!!!! The knob should be past the screw, with 1-2mm of the knob threads off the screw, it'll look something like this: | |||
[[File: Micro_swiss_extruder_levertension_for_TPU.jpg]] | |||
== Configs == | == Configs == | ||
| Line 57: | Line 66: | ||
'''Unzip these files to get to the .ini file inside! Prusaslicer looks for .ini'''. | '''Unzip these files to get to the .ini file inside! Prusaslicer looks for .ini'''. | ||
Best practise is to delete the previous settings (little "X" beside the preset drop down menu), then load this one | |||
{| cellpadding="5" cellspacing="0" border="1" | {| cellpadding="5" cellspacing="0" border="1" | ||
| Line 66: | Line 76: | ||
|- | |- | ||
| | | Jan 28, 2025 | ||
|Rana | |Rana | ||
|Config Bundle - Machine Profile and profiles for PETG, PLA, TPU | |Config Bundle - Machine Profile and profiles for PETG, PLA, TPU | ||
|[[File: | |[[File:PrusaSlicer_config_bundle_green_machine_with_pysical_printer.zip]] | ||
|Has the Green Machine (Ender 5 Plus) machine settings, | |Has the Green Machine (Ender 5 Plus) machine settings, dialed in settings for elegoo rapid PETG | ||
|- | |- | ||