P-touch Label Maker Manual: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 15: | Line 15: | ||
* Create the page at [https://knowledge.hacklab.to/wiki/HL00XX] | * Create the page at [https://knowledge.hacklab.to/wiki/HL00XX] | ||
** You can either immediately create a redirect (see [https://knowledge.hacklab.to/wiki/HL0001&redirect=no]) | ** You can either immediately create a redirect (see [https://knowledge.hacklab.to/wiki/HL0001&redirect=no]) | ||
<blockquote> | |||
Placeholder; Replace with the following; as required | |||
<source lang="reg"> | |||
<source lang="reg"> | |||
#REDIRECT [[ARTICLE_TITLE]] | |||
</source> | |||
</source> | |||
</blockquote> | |||
* Change the URL embedded in the QR Code | * Change the URL embedded in the QR Code | ||
* Change the text of the label | * Change the text of the label | ||
Latest revision as of 00:49, 3 May 2024
PT-P710BT P-touch CUBE Plus
Software is setup on shared computer HL0002
Creating QR codes
- Use the Main shared computer
- Connect the Label maker via USB, load the label maker with 18mm tape.
- Open the PTouch software (search PTouch using Windows start menu)
- In the saved labels open `Hacklab-QRcode-Tag.lbx`
- Determine the next number in the sequence - i.e. HL0079 -> HL0080
- Create the page at [1]
- You can either immediately create a redirect (see [2])
Placeholder; Replace with the following; as required
<source lang="reg">
#REDIRECT [[ARTICLE_TITLE]]</source>
- Change the URL embedded in the QR Code
- Change the text of the label
- SAVE THE LABEL
- This is how we determine the next number otherwise you have to search HL00* in the wiki.
- Print it out on HL0001 using White 18mm tape.
Second manual p-touch
FIXME