3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 21: | Line 21: | ||
* Upload and print | * Upload and print | ||
* Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | * Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | ||
== Camera Stream == | |||
Open with VLC | |||
File -> Open Network Stream | |||
rtsp://admin:@192.168.111.44:554/user=admin&password=&channel=1&stream=0.sdp | |||
Revision as of 00:09, 23 August 2016
!
Status
Operational
Usage
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r
Slic3r Settings
- Download the latest Slic3r
- Load config -- http://data.flamy.ca/printer_config/config.ini
- Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
- Select File -> Quck Slice and Save As.. or click on 'Send To Printer' (the l
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
Octoprint at octopi4.hacklab.to
- Octopi ui: http://octopi4.hacklab.to/
- Upload and print
- Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml
Camera Stream
Open with VLC File -> Open Network Stream rtsp://admin:@192.168.111.44:554/user=admin&password=&channel=1&stream=0.sdp