3D Printers/Prusa Mini 2: Difference between revisions
Jump to navigation
Jump to search
m (Revident moved page Prusa Mini 2 to 3D Printers/Prusa Mini 2) |
(→Status) |
||
| Line 1: | Line 1: | ||
== Status == | == Status == | ||
<onlyinclude> | <onlyinclude> | ||
* '''Broken''' | * '''Broken''' (Sort-of). Watch first layer as it prints and adjust z-offset! | ||
* '''http://prusa-mini-2.in.hacklab.to/''' | * '''http://prusa-mini-2.in.hacklab.to/''' | ||
</onlyinclude> | </onlyinclude> | ||
| Line 25: | Line 25: | ||
|- | |- | ||
|} | |} | ||
== Maintenance Log == | == Maintenance Log == | ||
Revision as of 03:49, 6 December 2023
Status
- Broken (Sort-of). Watch first layer as it prints and adjust z-offset!
- http://prusa-mini-2.in.hacklab.to/
Last Known Good Settings
| Date | Filament type, colour, brand | First layer | Other layers | Notes |
|---|---|---|---|---|
| July 29, 2020 | Generic PETG, Red and White | Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. This has now happened 3 times with the red PETG filament. Cleaning of the extender pulley also showed build of up the white PETG as well. The PEI print sheet has been significantly damaged from this.
A support case will be opened with Prusa. A new PEI build sheet will be ordered. Printer should NOT be used until after the support case with Prusa is resolved. |
Maintenance Log
Most recent entries at the top.
| Date | Notes | Entry By |
|---|---|---|
| July 29, 2020 |
|
Revident |