Drill Press: Difference between revisions

Revision as of 06:48, 1 January 2017

Hacklab acquired a 14" floor standing drill press on 2016-06-29. It lives in the corner of the shop, integrated into the table.

Check if spindle needs oil/grease and lube it if necessary.
The previous owner removed the middle pulley from the three-pulley 16-speed gearbox, reducing it to 1 belt and 4 speeds. The third pulley and the two belts are in a box under the drill press if anyone ever wants higher/lower speeds.

@@ Line 1: / Line 1: @@
-[[File:Drill Press.jpg|thumb|300px]]
+Hacklab acquired a 14" floor standing drill press on 2016-06-29.
+It lives in the corner of the shop, integrated into the table.
-Drill Press!!  Who hoo!
+[[File:FloorDrillPress.jpg|400px]]
-===YOU MUST WEAR SAFETY GLASSES===
+* Model: TradeMaster RDM-150F
+* 5/8" bit capacity
+* 14" throat (7" from column to bit)
+* 3" quill travel
+* A couple feet of vertical table travel
+* 1/2 HP motor
+* MT2 spindle
+* Made in 1983
-===DO NOT WEAR GLOVES===
+== Usage & Safety ==
-===BEWARE OF LOOSE CLOTHING===
+# You must be trained to operate this machine
+# Tie back long hair, remove long sleeved shirts and jewellery.
+# Eye protection must be worn when machine is running.
+# Check machine for damage before using.
+# No unconventional / unsafe use.
+# Do not use mill cutters in the drill press.
+# Use the vise and/or table clamp to keep work on the table
+# Sweep / vacuum up chips and leave the machine clean.
-===PROPERLY SECURE YOUR WORK===
+== Wishlist/TODO ==
+* Check if spindle needs oil/grease and lube it if necessary.
+* The previous owner removed the middle pulley from the three-pulley 16-speed gearbox, reducing it to 1 belt and 4 speeds. The third pulley and the two belts are in a box under the drill press if anyone ever wants higher/lower speeds.
-[[file:DrillPressSpeedAdjust.jpg|500px]]
-[[Category:Equipment]]