Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
(Add features, update status and log) |
||
| Line 1: | Line 1: | ||
[[File:Ultimaker 2.jpg|thumb|300px|Ultimaker #2, also known as "Fawkes"]] | [[File:Ultimaker 2.jpg|thumb|300px|Ultimaker #2, also known as "Fawkes"]] | ||
This page documents Ultimaker #2 (Fawkes) [A phoenix from the ashes] | This page documents Ultimaker #2 (Fawkes) [A phoenix from the ashes] | ||
Printer lives on the third shelf of the 3D printer tower, next to the [[Type A]]. | |||
==Status== | ==Status== | ||
<onlyinclude> | |||
* Operational | |||
* Some backlash | |||
* Loaded with orange-red 3mm PLA | |||
* '''Unload the orange-red PLA from the Bowden tube after use, it breaks apart and clogs the tube after several days!''' | |||
* '''PLA ONLY!''' (to prevent nozzle contamination) | |||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | |||
* '''http://octopi2.hacklab.to/'''</onlyinclude> | |||
* | == Features == | ||
* | |||
* Ultimaker Original with extruder drive upgrade | |||
* Built from an incomplete kit and a bunch of parts are 3D printed | |||
* 210 x 210 x 205 mm print volume | |||
* 3mm filament | |||
* Absolute max temperature: 250 C | |||
* It is managed and accessible from the web GUI: '''http://octopi2.hacklab.to/''' | * It is managed and accessible from the web GUI: '''http://octopi2.hacklab.to/''' | ||
| Line 15: | Line 30: | ||
!Entry By | !Entry By | ||
|- | |- | ||
|Mid-2016 | |||
|Re-printed [http://www.thingiverse.com/thing:19551 extruder drive tensioner] in ABS on Ultimaker 1, replaced Bowden tube coupler springs. Snipped 1cm off the tube ends to give couplers fresh surface to hold on to. | |||
|Igor | |||
|- | |||
|September 26, 2015 | |September 26, 2015 | ||