3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 16: | Line 16: | ||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | ||
==Octoprint at | ==Octoprint at octopi4.hacklab.to== | ||
* Octopi ui: http://octopi4.hacklab.to/ | |||
* Octopi ui: http:// | |||
* Upload and print | * Upload and print | ||
* Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | * Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | ||
Revision as of 23:50, 22 August 2016
!
Status
Operational
Usage
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r
Slic3r Settings
- Download the latest Slic3r
- Load config -- http://data.flamy.ca/printer_config/config.ini
- Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
- Select File -> Quck Slice and Save As.. or click on 'Send To Printer' (the l
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
Octoprint at octopi4.hacklab.to
- Octopi ui: http://octopi4.hacklab.to/
- Upload and print
- Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml