3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
(→Usage) |
|||
| Line 14: | Line 14: | ||
* Load config -- http://data.flamy.ca/printer_config/config.ini | * Load config -- http://data.flamy.ca/printer_config/config.ini | ||
* Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini | * Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini | ||
* Select File -> Quck Slice and Save As.. or click on 'Send To Printer' | * Select File -> Quck Slice and Save As.. or click on 'Send To Printer' | ||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | ||
Revision as of 23:30, 29 December 2016
!
Status
Operational
Usage
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r
Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html
Slic3r Settings
- Download the latest Slic3r
- Load config -- http://data.flamy.ca/printer_config/config.ini
- Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
- Select File -> Quck Slice and Save As.. or click on 'Send To Printer'
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
Octoprint at octopi4.hacklab.to
- Octopi ui: http://octopi4.hacklab.to/
- Upload and print
- Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml
Camera Stream
Open with VLC File -> Open Network Stream rtsp://admin:@192.168.111.44:554/user=admin&password=&channel=1&stream=0.sdp