3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
(Camera stream no longer available) |
(Added maintenance resources and log) |
||
| Line 23: | Line 23: | ||
* Upload and print | * Upload and print | ||
* Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | * Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | ||
== Maintenance Resources == | |||
Cleaning the Extruder Drive Gear on a FlashForge Creator Pro 3D Printer -- https://www.youtube.com/watch?v=vmIY9_6s8Ss | |||
Flashforge Creator Pro ABS Nozzle Cleaning -- https://www.youtube.com/watch?v=x3yp6H4D_ao | |||
| Line 33: | Line 38: | ||
!Entry By | !Entry By | ||
|- | |- | ||
| Jan 26, 2017 | |||
| Replaced Fillament with Orange Monoprice. Cleaned nozzles, drive gears. Right gear doesn't pull fillament properly. Either gear or nozzle needs to be replaced. | |||
| Dec 29, 2016 | | Dec 29, 2016 | ||
Revision as of 03:30, 27 January 2017
Status
Operational
Usage
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r
Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html
Slic3r Settings
- Download the latest Slic3r
- Load config -- http://data.flamy.ca/printer_config/config.ini
- Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
- Select File -> Quck Slice and Save As.. or click on 'Send To Printer'
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
Octoprint at octopi4.hacklab.to
- Octopi ui: http://octopi4.hacklab.to/
- Upload and print
- Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml
Maintenance Resources
Cleaning the Extruder Drive Gear on a FlashForge Creator Pro 3D Printer -- https://www.youtube.com/watch?v=vmIY9_6s8Ss Flashforge Creator Pro ABS Nozzle Cleaning -- https://www.youtube.com/watch?v=x3yp6H4D_ao
Maintenance Log
Most recent entries at the top.
| Date | Notes | Entry By | ||
|---|---|---|---|---|
| Jan 26, 2017 | Replaced Fillament with Orange Monoprice. Cleaned nozzles, drive gears. Right gear doesn't pull fillament properly. Either gear or nozzle needs to be replaced. | Dec 29, 2016 | Bed level adjusted. Heated bed support needs to be disassembled and left front (my left) leveling assembly needs to be readjusted | Alex V. |
| Nov 29, 2016 | Right Extruder cleaned, Left Extruder should be clean too | Rana |