Hacky New Years/2023: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
No edit summary |
||
| Line 27: | Line 27: | ||
=== Solder right angle header to 'CN-Tower-Resistor' PCB === | === Solder right angle header to 'CN-Tower-Resistor' PCB === | ||
* Make sure the plastic is on the side of the PCB with the white outline. | * Make sure the plastic is on the side of the PCB with the white outline. | ||
* The 3x2 programming header can be used to support the PCB while soldering right angle header. This allows | * The 3x2 programming header can be used to support the PCB while soldering right angle header. This allows the PCB to lay flat on a work surface and will not tip over when soldering. | ||
[[File:Hny23-assembly-right-angle-placement.jpg|400px]] | [[File:Hny23-assembly-right-angle-placement.jpg|400px]] | ||
| Line 39: | Line 38: | ||
=== Solder programming header to Main PCB (Optional) === | === Solder programming header to Main PCB (Optional) === | ||
=== Solder'CN-Tower-Resistor' PCB perpendicular to Main PCB === | === Solder'CN-Tower-Resistor' PCB perpendicular to Main PCB === | ||
| Line 46: | Line 43: | ||
* A roll of Electrical Tape is about the correct height to aid in this next step. | * A roll of Electrical Tape is about the correct height to aid in this next step. | ||
* Place the Main PCB atop the electrical tape, with the 'CN-Tower-Resistor' PCB inserted below and supported by the work surface. | * Place the Main PCB atop the electrical tape, with the 'CN-Tower-Resistor' PCB inserted below and supported by the work surface. | ||
* '''Solder only the First pin right angle header!''' (the one closest to the viewer in the photo | * '''Solder only the First pin right angle header!''' (the one closest to the viewer in the photo) | ||
[[File:Hny23-assembly-tower-soldering-jig.jpg|400px]] | [[File:Hny23-assembly-tower-soldering-jig.jpg|400px]] | ||
* Pickup the whole assemble | * Pickup the whole assemble. | ||
* While reheating the solder joint of the first pin, adjusting the positioning of the 'CN-Tower-Resistor' PCB to be perpendicular over the LEDs on the Main PCB. | |||
[[File:Hny23-assembly-tower-soldering-adjustment.jpg|400px]] | [[File:Hny23-assembly-tower-soldering-adjustment.jpg|400px]] | ||