Ultimaker 1
This page documents Ultimaker #1 (Guy)
Status
- This Ultimaker is currently functional and in reasonable to good condition!
Machine Log
| Date | Notes | Entry By |
|---|---|---|
| April 27, 2013 | Print quality degraded significantly mid-print. Hot end disassembled, burnt PLA removed from brass tube, and dust/dirt removed from teflon-PEEK interface. Print quality returned to normal. PLA diameter changed. |
Norm |
| April 24, 2013 | Squeaking noise observed from Y axis axle. Endcap inset screw noticed to be loose, requires new endcap to be printed, and screw not to be overtightened. |
Norm |
| April 12, 2013 | Bed leveling assist tool printed and built. | Norm |
| April 8, 2013 | Belts retensioned, new bearing endcaps installed to reduce backlash further. | Norm |
| April 6, 2013 | Z axis calibration fixed, Z steps/mm in new profile on Git. X/Y axis backlash observed, infill not meeting walls, delamination observed. |
Norm |
| March 31, 2013 | Z axis calibration issues observed. 25mm Test cube showed ~6.8% Z axis error. |
Norm |