3D Printers/Ender 5 plus
Status
Last Known Good Settings
| Date | Filament type, colour, brand | First layer | Other layers | Notes |
|---|---|---|---|---|
| June 28, 2020 | asdfsadfsdaf | asfsadfsadf |
Hardware
- screen is Big Tree Tech TFT35-E3 V3.0
- mainboard is Big Tree Tech SKR Mini E3 V2.0
- power supply is Mean Well RSP-500-24 (the good one, not first release of this printer that had a shitty one)
- Printhead is Micro Swiss Direct Drive and All-Metal Hot end
- Probe is official BL-Touch (which is stock on the E5P)
- it should be set and forget, don't think it needs to be recalibrated ever unless some hardware thing changes
- can use 'babystep' feature to live z-adjust during printing
- refer to this for setting the probe offset https://www.youtube.com/watch?v=y_1Kg45APko
Software
To use pronterface to control the printer, first power up the printer, then connect the usb cable to your computer. On win10 it should auto-detect and possibly install 'maple' (wtf that is lol). Baud 115200
Calibration notes
- using the built in e-steps I got 137.85 steps/mm
Printable Upgrades
https://www.thingiverse.com/thing:4742487 https://www.thingiverse.com/thing:4742501
Voron cooling fans: https://www.thingiverse.com/thing:5171295
Z-axis sync indicators: https://www.thingiverse.com/thing:4460521
Glass Print Plate Usage
Usage
SD Card
Slicer Settings
* Using Cura, seems to be what most people are using
- flow settings are "hard-baked" into extrusion values in the gcode. So if you set flow to 95% in cura, there will NOT be an M221 S95 command in the gcode and so the printer will say on its screen that flow is 100%, but really the flow has been reduced.
A few random printing tips
know what you're doing!!! this printer is for seasoned vets only!!
Octoprint at octopi4.hacklab.to
I wish...
Maintenance Resources
put stuff here lol
Maintenance Log
Most recent entries at the top.
| Date | Notes | Entry By |
|---|---|---|
| June 9, 2022 | Setting up the printer | Rana |