3D Printers/Ender 3 2

From Hacklab.TO Public Wiki
Jump to navigation Jump to search

Status

  • Works sort-of
  • Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm
  • Print-bed is very low quality. Likely to cause warping on bottom of print.
  • Upload G-Code to Micro-SD Card
  • Octoprint at octopi04.in.hacklab.to


Last Known Good Settings

Date Filament type, colour, brand First layer Other layers Notes

Maintenance Log

2024-02-25

Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off.

Retrieved from "https://knowledge.hacklab.to//index.php?title=3D_Printers/Ender_3_2&oldid=2354"