3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 23:50, 22 August 2016
, 22 August 2016no edit summary
No edit summary |
No edit summary |
||
| Line 16: | Line 16: | ||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | ||
==Octoprint at | ==Octoprint at octopi4.hacklab.to== | ||
* Octopi ui: http://octopi4.hacklab.to/ | |||
* Octopi ui: http:// | |||
* Upload and print | * Upload and print | ||
* Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | * Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml | ||