3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 00:15, 23 August 2016
, 23 August 2016→Usage
No edit summary |
(→Usage) |
||
| Line 6: | Line 6: | ||
== Usage == | == Usage == | ||
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on [http://slic3r.org/ Slic3r] | Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on [http://slic3r.org/ Slic3r] | ||
Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html | |||
==Slic3r Settings== | ==Slic3r Settings== | ||