3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 23:25, 9 February 2017
, 9 February 2017→Slic3r Settings
| Line 29: | Line 29: | ||
* Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini | * Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini | ||
* Select File -> Quck Slice and Save As.. or click on 'Send To Printer' | * Select File -> Quck Slice and Save As.. or click on 'Send To Printer' | ||
Faster slicer configuration | |||
* config.ini -- http://data.flamy.ca/printer_config/slic3r_config_tweaks/fast_config_002_adjusted/config.ini | |||
* slic3r_config_bundle.ini -- http://data.flamy.ca/printer_config/slic3r_config_tweaks/fast_config_002_adjusted/Slic3r_config_bundle.ini | |||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | ||