3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 19:21, 16 April 2017
, 16 April 2017→Print Settins
| Line 52: | Line 52: | ||
These are general printer settings that work. If filament has different temperature settings, follow filament temperature settings. | These are general printer settings that work. If filament has different temperature settings, follow filament temperature settings. | ||
Smaller prints will better adhere to the bed than larger prints. If the print hasn't failed in the first 10% of the print job, it will unlikely to fail after that. | |||
Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | ||
| Line 75: | Line 77: | ||
'''ABS:''' | '''ABS:''' | ||
In Slic3r in Fillament Settings tab, '''ABS Right''' filament profile and in Print Settings tab, '''ABS_first_layer''' print profile. Currently profile is set to 6 skirt layers -- this is normal, ABS needs wide skirt for better adhesion to the bed. | In Slic3r in Fillament Settings tab, '''ABS Right''' filament profile and in Print Settings tab, '''ABS_first_layer''' print profile. Currently profile is set to 6 skirt layers -- this is normal, ABS needs wide skirt for better adhesion to the bed. | ||
When printing, you '''absolutely have to''' have a heated chamber, or ABS prints will definitely warp and very likely will not stick to kapton tape. | When printing, you '''absolutely have to''' have a heated chamber, or ABS prints will definitely warp and very likely will not stick to kapton tape. | ||