251
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 01:01, 28 April 2017
, 28 April 2017→Print Settings
| Line 88: | Line 88: | ||
*when bed is cool, wipe the kapton tape clean with acetone (I used a paper towel with acetone on it) | *when bed is cool, wipe the kapton tape clean with acetone (I used a paper towel with acetone on it) | ||
*take a clean paper towel, put acetone on it and wipe a piece of the ABS with it to get some 'ABS juice' on the towel. Then wipe this over the bed. There should be some failed prints in the 3D printer, or check the mini-can beside the 3D printer for failed prints | *take a clean paper towel, put acetone on it and wipe a piece of the ABS with it to get some 'ABS juice' on the towel. Then wipe this over the bed. There should be some failed prints in the 3D printer, or check the mini-can beside the 3D printer for failed prints | ||
*allow to dry completely (~5 minutes), you should see streaks on the bed | *allow to dry completely (~5 minutes), you should see streaks of ABS on the bed. Heat up bed and print as usual. | ||
*ABS should now stick well. Remember to block the build volume to stop air drafts. | *ABS should now stick well. Remember to block the build volume to stop air drafts. | ||
------ | ------ | ||