Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
m
→Status
(→Status: update based on what done last week.) |
m (→Status) |
||
| Line 7: | Line 7: | ||
* Operational | * Operational | ||
* WHITE: 2.85mm PLA (use 210°-220°) | * WHITE: 2.85mm PLA (use 210°-220°) | ||
* BLACK: 2.85mm PLA/PHA Filament (use 220°-230°)-- this is a bit more flexible than plain PLA | * BLACK: 2.85mm PLA/PHA Filament (use 220°-230°) -- this is a bit more flexible than plain PLA | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* '''Heated bed currently not working''' (mid-way through fixing that). | * '''Heated bed currently not working''' (mid-way through fixing that). | ||