83
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
Successful dual-extrusin print. OctoPi4 IP fixed. Move SD card notes into separate section to shorten status.
No edit summary |
(Successful dual-extrusin print. OctoPi4 IP fixed. Move SD card notes into separate section to shorten status.) |
||
| Line 3: | Line 3: | ||
== Status == | == Status == | ||
<onlyinclude> | <onlyinclude> | ||
* Operational | * Operational | ||
* [[#Usage|Slic3r Settings here]] | |||
* [[ | |||
* '''http://octopi4.hacklab.to/''' | * '''http://octopi4.hacklab.to/''' | ||
* [[#SD Card|Or print without OctoPrint using the SD Card]] | |||
</onlyinclude> | </onlyinclude> | ||
| Line 15: | Line 13: | ||
* FlashForge Creator Pro | * FlashForge Creator Pro | ||
* 225 x 145 x 150 mm print volume | * 225 x 145 x 150 mm print volume | ||
* Dual extruder | * Dual extruder | ||
* 1.75mm filament | * 1.75mm filament | ||
| Line 31: | Line 29: | ||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | ||
== SD Card == | |||
You can print from the printer directly by putting your print file on an SD card, there is one already in the printer. It only accepts x3g files, so you will have to convert your .gcode file (made in slic3r) to x3g using this utility http://markwal.github.io/GpxUi/ | |||
==Slic3r Settings== | ==Slic3r Settings== | ||
| Line 129: | Line 130: | ||
!Notes | !Notes | ||
!Entry By | !Entry By | ||
|- | |||
| May 17, 2017 | |||
| Pi configured with static IP in /etc/dhcpcd.conf. | |||
Nozzles aligned vertically, successfully printed PLA with PVA support: 210°C for both extruders, bed off, blue tape. | |||
| Igor | |||
|- | |- | ||