Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
m
→Status: edit for clarity
(→Status: add back accidentally deleted line) |
m (→Status: edit for clarity) |
||
| Line 10: | Line 10: | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! (O.K. for small X/Y size prints.) | ** Bed was leveled but Print Bed is NOT perfectly flat! (O.K. for small X/Y size prints.) | ||
** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z- | ** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer of plastic becomes flat. | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Loaded with Bright Yellow 2.85mm PLA | * Loaded with Bright Yellow 2.85mm PLA | ||