Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: REBUILD EXTRUDER
No edit summary |
(→Machine Log: REBUILD EXTRUDER) |
||
| Line 39: | Line 39: | ||
!Notes | !Notes | ||
!Entry By | !Entry By | ||
|- | |||
|Jun 8-9, 2017 | |||
|'''Extruder DIED!''' | |||
* Totally rebuild this using new printed parts. | |||
** Everything except the Bearing Cap and the Large Gear was reprinted (on Ultimaker 1) | |||
** Printed with PLA using: 4 Perimiter lines (1.6mm); Top/Bottom 1.6mm; 100% Fill. | |||
* The old-style (ABS) Filament Compression Arm was labeled & put in the Printer Parts basket. | |||
* The tention block is now almost too big. (Grove side up & only goes 1/2 block length in.) | |||
|Allen | |||
|- | |||
|Jun 7, 2017 | |||
|Lubricate the Z screw using Superlube Synthetic Grease. | |||
|Allen | |||
|- | |- | ||