251
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
*'''Last known good settings''': (16-July-2017) 30 mm/s, 120% flow, 0.4 mm nozzle size. Yea it's slow but it prints pretty well. Printed at 40 mm/s, parts are structurally sound but some layers are blotchy and it doesn't look clean. | *'''Last known good settings''': (16-July-2017, pink PLA) 30 mm/s, 120% flow, 0.4 mm nozzle size. Yea it's slow but it prints pretty well. Printed at 40 mm/s, parts are structurally sound but some layers are blotchy and it doesn't look clean. | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||