Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Status: update based on recent use
(→Status: update based on recent use) |
|||
| Line 6: | Line 6: | ||
<onlyinclude> | <onlyinclude> | ||
* Operational | * Operational | ||
* WHITE: 2.85mm PLA | * '''Last known good settings:''' 220°, 110% flow, 50mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* WHITE: 2.85mm PLA ... or BLACK: 2.85mm PLA/PHA Filament (this is a bit more flexible than plain PLA) | |||
* | * The Z axis Zero Stop set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. (Hard filaments need to be just slightly closer to stick to the tape sheet.) | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||