Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Status: DOWN ... thermocouple problem
(→Machine Log: Fan Duct failed again. X home problems.) |
(→Status: DOWN ... thermocouple problem) |
||
| Line 5: | Line 5: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* | * '''DOWN''' ... Thermocouple failure ... '''DO NOT USE'''. | ||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||