Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: Update status for working
m (→Machine Log: formatting edit) |
(→Status: Update status for working) |
||
| Line 8: | Line 8: | ||
Black PLA/PHA Filament to print parts for "Mother of all Cable Racks" Project. | Black PLA/PHA Filament to print parts for "Mother of all Cable Racks" Project. | ||
*'''Last known good settings''': (28-Sept-2017, PLA/PHA) '''220°''', 110% flow, print @ '''30mm/s''' (1/2 speed), travel @ '''60mm/s''' (also 1/2 speed), 0.4 mm nozzle size, 2.85mm filament size. | *'''Last known good settings''': (28-Sept-2017, PLA/PHA) '''220°''', 110% flow, print @ '''30mm/s''' (1/2 speed), travel @ '''60mm/s''' (also 1/2 speed), 0.4 mm nozzle size, 2.85mm filament size. | ||
* ''' | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ||