Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
m
→Status
(→Known Issues and Fixes: add IPG Blue Tape note) |
m (→Status) |
||
| Line 8: | Line 8: | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* OLD crap | * OLD crap Translucent Red PLA. (Do '''not''' use with anything that is constantly retracting.) | ||
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | * There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | ||
* The Carbon Fiber Plate flatness is only "good enough". (It seems to have a slightly high center.) | * The Carbon Fiber Plate flatness is only "good enough". (It seems to have a slightly high center.) | ||