Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: update for last known status
m (→Status) |
(→Status: update for last known status) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* | * '''Needs Work''' ... Do not use! | ||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* | * Black PLA/PHA (This needs different retraction settings from PLA.) | ||
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | * There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | ||
* The Carbon Fiber Plate flatness is only "good enough". ( | * The Carbon Fiber Plate flatness is only "good enough". (A bent rod at the front makes it seems to have a slightly high center.) | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ||