3D Printers/Ender 3 2: Difference between revisions
Jump to navigation
Jump to search
no edit summary
(→Status) |
No edit summary |
||
| Line 5: | Line 5: | ||
* '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | * '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | ||
* '''Upload G-Code to Micro-SD Card''' | * '''Upload G-Code to Micro-SD Card''' | ||
* Octoprint at '''[http://octopi04.in.hacklab.to octopi04.in.hacklab.to]''' | |||
</onlyinclude> | </onlyinclude> | ||