3D Printers: Difference between revisions

3D Printers (view source)

234 bytes added , 24 May 2015

12

edits

@@ Line 69: / Line 69: @@
 === Quick Start Instructions ===
-# Generate gcode from an STL using printer-specific software.
+# Generate Gcode from an STL using printer-specific software. Here are [[Ultimaker Slicing Page|instructions on using Cura]] for the Ultimaker machines.
-# Open tegh, select printer by IP address (written on each 3d printer)
+# Visit the OctoPrint web interface for the printer you're using:
-# Upload gcode to printer via 'add_job (path_to_file.gcode)'
+#* Ultimaker 1 - http://octopi.hacklab.to
-# Set extruder temperature via 'set temp e0: 220'
+#* Ultimaker 2 - http://octopi2.hacklab.to
-# Start print job when at temperature via 'print'
+#* Type A - http://octopi.hacklab.to:5001
+# Upload Gcode to the printer using the web interface.
-Command details via the 'help' command, and on the [[Construct Protocol]] page.
+# Click print and wait.
+# When finished, make sure you do the following steps:
+#* Clean up bed and machine for the next user.
+#* Delete the file on OctoPrint if you are done with it.
+#* Turn the machine off.
 == Troubleshooting ==