3D Printers/FlashForge Creator Pro
!
Status
Operational
Usage
Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r
Slic3r Settings
- Download the latest Slic3r
- Load config -- http://data.flamy.ca/printer_config/config.ini
- Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
- Select File -> Quck Slice and Save As.. or click on 'Send To Printer' (the l
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
Octoprint at 192.168.111.94
Please, someone set DNS name to octopi4
- Octopi ui: http://192.168.111.94/
- Upload and print
- Octopi config file (backup, if raspberry pi gets messed up) -- http://data.flamy.ca/printer_config/config.yaml