3D Printers/CR10 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(Created page with "== Status == <onlyinclude> * '''Works!''' * '''octoprint01.in.hacklab.to''' </onlyinclude> ----- Last Known Good Settings {| cellpadding="5" cellspacing="0" border="1" !Date...") |
(→Status) |
||
(5 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
<onlyinclude> | <onlyinclude> | ||
* '''Works!''' | * '''Works!''' | ||
* ''' | * It's SD card reader has a broken latch. You have to use the octoprint web interface to upload gcode. | ||
* '''[http://octopi01.in.hacklab.to:5000 octopi01.in.hacklab.to:5000]''' | |||
</onlyinclude> | </onlyinclude> | ||
----- | ----- | ||
Last Known Good Settings | |||
== Last Known Good Settings == | |||
{| cellpadding="5" cellspacing="0" border="1" | {| cellpadding="5" cellspacing="0" border="1" | ||
!Date | !Date | ||
Line 13: | Line 15: | ||
!Other layers | !Other layers | ||
!Notes | !Notes | ||
!Entry By | |||
|- | |||
| PLA | |||
| N/A | |||
| N/A | |||
| N/A | |||
| Used default Prusa Slicer profile | |||
| chalmers | |||
|- | |- | ||
| | |} | ||
----- | |||
== Maintenance Log == | |||
Most recent entries at the top. | |||
{| cellpadding="5" cellspacing="0" border="1" | |||
!Date | |||
!Notes | |||
!Entry By | |||
|- | |||
| December 04 2023 | |||
| | | | ||
* Added an octoprint server to this CR10. It's sd-card reader is busted, so this seemed the easiest way to get it up and running again. | |||
* Bought glue sticks and applied glue to it's build plate | |||
| | * Performed some bed levelling. | ||
| Chalmers | |||
|- | |- | ||