3D Printers/Ender 3 2: Difference between revisions
Jump to navigation
Jump to search
no edit summary
(Created page with "== Status == <onlyinclude> * '''Works sort-of''' * '''Hot end sometimes fails to get to temperature, and the firmware freaks out and triggers an alarm''' * '''Print-bed is ver...") |
No edit summary |
||
| (One intermediate revision by one other user not shown) | |||
| Line 5: | Line 5: | ||
* '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | * '''Print-bed is very low quality. Likely to cause warping on bottom of print.''' | ||
* '''Upload G-Code to Micro-SD Card''' | * '''Upload G-Code to Micro-SD Card''' | ||
* Octoprint at '''[http://octopi04.in.hacklab.to octopi04.in.hacklab.to]''' | |||
</onlyinclude> | </onlyinclude> | ||
| Line 23: | Line 24: | ||
|- | |- | ||
|} | |} | ||
== Maintenance Log == | |||
=== 2024-02-25 === | |||
Atrain modified the USB cables between printer and OctoPrint Raspberry Pi. This prevents the RPi from back-powering the printer logic board while the printer is powered off. | |||