3D Printers/Ender 5 plus: Difference between revisions

3D Printers/Ender 5 plus (view source)

200 bytes added , 1 November 2023

111

edits

@@ Line 75: / Line 75: @@
 ==Slicer Settings==
- * Using Cura, seems to be what most people are using
+Use the config bundle for prusa slicer, a copy is in this wiki under 'usage' and another copy is on the USB drive.
-** flow settings are "hard-baked" into extrusion values in the gcode. So if you set flow to 95% in cura, there will NOT be an M221 S95 command in the gcode and so the printer will say on its screen that flow is 100%, but really the flow has been reduced.
+Keep in mind that this printer has a 1mm nozzle installed. The slicer settings I uploaded set the line width to 1.2mm and layer height to 0.6mm. So for an object with 1 perimeter is the equivalent of 3 perimeters with a 0.4 nozzle (so decently strong). So for most objects 1 perimeter and 3 top/bottom layers is plenty of plastic and will be strong enough. This will save a shitload of time!!
 ==A few random printing tips==