3D Printers/Ender 5 plus

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
Ender 5 Plus

Status


Last Known Good Settings

Date Filament type, colour, brand First layer Other layers Notes
Nov 1, 2023 PETG, translucent green, polymaker noz: 250, bed 90 noz: 250: bed 80

Hardware

  • Probe is official BL-Touch (which is stock on the E5P)
    • it should be set and forget, don't think it needs to be recalibrated ever unless some hardware thing changes
    • can use 'babystep' feature to live z-adjust during printing
    • refer to this for setting the probe offset https://www.youtube.com/watch?v=y_1Kg45APko

Software

To use pronterface to control the printer, first power up the printer, then connect the usb cable to your computer. On win10 it should auto-detect and possibly install 'maple' (wtf that is lol). Baud 115200


Calibration notes

  • using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate)

Printable Upgrades

https://www.thingiverse.com/thing:4742487 https://www.thingiverse.com/thing:4742501

Voron cooling fans: https://www.thingiverse.com/thing:5171295

Z-axis sync indicators: https://www.thingiverse.com/thing:4460521

Print bed usage

The glass plate has a magnetic underside which as been heat fused to the aluminum bed lol. So it is more or less permanently stuck on there. Use the spring steel PEI plate, secure it to the black clips.

Wait for the PEI sheet to cool before removing your prints, take it off the bed and it will cool faster. PETG can rip off the PEI coating if it too hot.

Usage

- there is no octoprint or other network connection set up yet. There is usb port on the side of the touchscreen and there should be a usb stick in it, use that

- use this config file for prusaslicer Media:PrusaSlicer_E5P_config_bundle_physical_printer.zip

- to load the filament push it all the way through the tubing to the direct drive extruder, then can use the knob on the extruder to load it down to the nozzle

- always check the first layer!!! there is live z-adjust on the touchscreen called "baby steps"

SD Card

Slicer Settings

Use the config bundle for prusa slicer, a copy is in this wiki under 'usage' and another copy is on the USB drive.

Keep in mind that this printer has a 1mm nozzle installed. The slicer settings I uploaded set the line width to 1.2mm and layer height to 0.6mm. So for an object with 1 perimeter is the equivalent of 3 perimeters with a 0.4 nozzle (so decently strong). So for most objects 1 perimeter and 3 top/bottom layers is plenty of plastic and will be strong enough. This will save a shitload of time!!

A few random printing tips

just pray to the right god lol

Octoprint at octopi4.hacklab.to

I wish...

Maintenance Resources

put stuff here lol

Maintenance Log

Most recent entries at the top.

Date Notes Entry By
June 9, 2022 Setting up the printer Rana