111
edits
(3 intermediate revisions by 2 users not shown) | |||
Line 169: | Line 169: | ||
==A few random printing tips== | ==A few random printing tips== | ||
Smaller prints will better adhere to the bed than larger prints. If the print hasn't failed in the first 10% of the print job, it will be unlikely to fail after that. | *Smaller prints will better adhere to the bed than larger prints. If the print hasn't failed in the first 10% of the print job, it will be unlikely to fail after that. | ||
Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | *Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | ||
Do not use honeycomb -- as at the speeds of the default settings, it will cause printer to resonate and skip. | *Do not use honeycomb -- as at the speeds of the default settings, it will cause printer to resonate and skip. | ||
Leaning or drifting prints? Tighten all the belts, especially the Y-axis stepper motor belt. That stepper is prone to becoming loose because the Y-stepper motor puts out more power than the X. A link to a video is in the maintenance section. | *Leaning or drifting prints? Tighten all the belts, especially the Y-axis stepper motor belt. That stepper is prone to becoming loose because the Y-stepper motor puts out more power than the X. A link to a video is in the maintenance section. | ||
*Always store the printer with the X carriage in a corner. (It homes itself to the back left corner anyway when a print is done). But this is to prevent the X and Y axis rods from sagging over time, especially the X axis. It's a known problem, I think, I swear I read it on the internet! | |||
==Octoprint at octopi4.hacklab.to== | ==Octoprint at octopi4.hacklab.to== | ||
Line 204: | Line 206: | ||
!Notes | !Notes | ||
!Entry By | !Entry By | ||
|- | |||
| Jan 16, 2019 | |||
| Loosened the Y-axis short belt, lol. In my zeal I tightened it too much, I guess... (the prints were still drifting back a little, the vertical lines were wobbly...) The belt is good now I think, it should make a low sound when you strum the belt. Also changed the screws holding the Y-stepper, added washer and a rubber ring to keep it in place. | |||
| Rana | |||
|- | |- | ||
Line 281: | Line 288: | ||
|} | |} | ||
[[Category:3D Printers]] |