3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 18:12, 28 January 2020
, 28 January 2020→Usage
(→Status) |
(→Usage) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 22: | Line 22: | ||
| Default Slic3r bundle settings | | Default Slic3r bundle settings | ||
| Default Slic3r bundle settings | | Default Slic3r bundle settings | ||
| | | == Last known good workflow (for Chalmers) == | ||
0. Glue stick the build plate | |||
1. Install slicer config | 1. Install slicer config | ||
2. Install slicer config bundle | 2. Install slicer config bundle | ||
3. set slicer to simple mode | 3. set slicer to simple mode | ||
4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | 4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | ||
5. slice model | 5. slice model | ||
6. load sliced model into GpxUi | 6. load sliced model into GpxUi | ||
7. translate to Replicator 2 RepRap | 7. translate to Replicator 2 RepRap | ||
|- | |- | ||
| Nov, 2018 | | Nov, 2018 | ||
Line 84: | Line 93: | ||
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended. | However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended. | ||
Use Instructions in the log from Jan 2020 at the top of this wiki. | |||
It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint. | It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint. |