3D Printers/FlashForge Creator Pro: Difference between revisions

Jump to navigation Jump to search
(One intermediate revision by the same user not shown)
Line 23: Line 23:
| Default Slic3r bundle settings
| Default Slic3r bundle settings
| == Last known good workflow (for Chalmers) ==
| == Last known good workflow (for Chalmers) ==
0. Glue stick the build plate
1. Install slicer config
1. Install slicer config


Line 91: Line 93:
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended.
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended.


Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html
Use Instructions in the log from Jan 2020 at the top of this wiki.
This link is dead, are there instructions anywhere else? --[[User:Hiker|Hiker]] ([[User talk:Hiker|talk]]) 19:14, 22 April 2018 (EDT)


It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint.
It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint.

Navigation menu