3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 23:30, 26 February 2024
, 26 Februaryno edit summary
(→Status) |
No edit summary |
||
| (8 intermediate revisions by 2 users not shown) | |||
| Line 3: | Line 3: | ||
== Status == | == Status == | ||
<onlyinclude> | <onlyinclude> | ||
* ''' | * '''Abandoned - Trash''' | ||
</onlyinclude> | </onlyinclude> | ||
| Line 18: | Line 15: | ||
!Notes | !Notes | ||
|- | |- | ||
| 2023 | |||
| N/A | |||
| N/A | |||
| N/A | |||
| | |||
* Work began to convert this machine over to modern electronics ( SKR board, etc.) But was abandoned when 4 new creality printers showed up unexpectedly. Given the quality and constraints of this printer, there is no value to it beyond as a parts machine. - ATrain | |||
|- | |||
| June 28, 2020 | |||
| N/A | |||
| N/A | |||
| N/A | |||
| | |||
* This Machine has been a poor state of repair. Filament is jamming when members attempt to use it. | |||
* Use of the two new Prusa Mini printers is highly encouraged. -Revident | |||
|- | |||
| Jan 2020 | | Jan 2020 | ||
| Blue PETG | | Blue PETG | ||
| Default Slic3r bundle settings | | Default Slic3r bundle settings | ||
| | | Default Slic3r bundle settings | ||
| Last known good workflow (for Chalmers) | | == Last known good workflow (for Chalmers) == | ||
0. Glue stick the build plate | |||
1. Install slicer config | |||
2. Install slicer config bundle | |||
3. set slicer to simple mode | |||
4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | |||
5. slice model | |||
6. load sliced model into GpxUi | |||
7. translate to Replicator 2 RepRap | |||
|- | |- | ||
| Nov, 2018 | | Nov, 2018 | ||
| Line 84: | Line 106: | ||
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended. | However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended. | ||
Use Instructions in the log from Jan 2020 at the top of this wiki. | |||
It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint. | It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint. | ||