3D Printers/Prusa Mini 2: Difference between revisions

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
No edit summary
 
Line 1: Line 1:
== Status ==
== Status ==
<onlyinclude>
<onlyinclude>
* '''Broken''' (Sort-of). Watch first layer as it prints and adjust z-offset!
* '''Working Great'''
* '''http://prusa-mini-2.in.hacklab.to/'''
* '''http://prusa-mini-2.in.hacklab.to/'''
</onlyinclude>
</onlyinclude>
Line 18: Line 18:
|
|
|
|
| Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. This has now happened 3 times with the red PETG filament. Cleaning of the extender pulley also showed build of up the white PETG as well. The PEI print sheet has been significantly damaged from this.
|
 
A support case will be opened with Prusa. A new PEI build sheet will be ordered.
 
Printer should NOT be used until after the support case with Prusa is resolved.
|-
|-
|}
|}
Line 33: Line 29:
!Notes
!Notes
!Entry By
!Entry By
|-
| Dec 15, 2023
|
* Firmware update, 4.4.0 => 5.1.2. This now supports input shaping!
* Update your prusa-slicer to take advantage, you have to add a new printer model.
|
|-
| 2020-2023
| Previously, Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. A support case was be opened with Prusa. Various repair attempts were completed. This was eventually solved with various hardware and software fixes.
|
|-
|-
| July 29, 2020
| July 29, 2020

Latest revision as of 23:20, 26 February 2024

Status



Last Known Good Settings

Date Filament type, colour, brand First layer Other layers Notes
July 29, 2020 Generic PETG, Red and White

Maintenance Log

Most recent entries at the top.

Date Notes Entry By
Dec 15, 2023
  • Firmware update, 4.4.0 => 5.1.2. This now supports input shaping!
  • Update your prusa-slicer to take advantage, you have to add a new printer model.
2020-2023 Previously, Mini # has demonstrated an intermittent problem of with it's Z position. Some runs will start at the calibrated height and z-adjustment. Others will start even lower into the bed. This as result in back pressure, causing the extruder pulley to grind the filament. A support case was be opened with Prusa. Various repair attempts were completed. This was eventually solved with various hardware and software fixes.
July 29, 2020
  • Third filament jam. removed boden tube from extrude motor assemble, and was able to pull the filament out form both ends. No disassemble was required.
  • Significant build of up plastic in extruder pulley teeth. Scrapped it out with a dental pick.
  • Replaced missing zip tie for cable bundle from extender assembly. This was a left over from Igor's previous disassemble for the second major jam.
Revident